News

By: Lynn Zhang | Audio Manufacturing Specialist ,CEO of Jingyi Audio Published: December 30, 2025 Reading Time: 5 Minutes Author's Note: I’ve been on enough stages to know that specific sinking feeling when the strobe hits just a fraction of a se...

2–3 SENTENCE SUMMARY A high potential (Hipot) / dielectric withstand test is a controlled high-voltage check across a cable’s insulation to confirm it won’t arc, break down, or leak abnormally under electrical stress. OEM/ODM audio cable m...

By Lynn Zhang, CEO at Jingyi Audio (Expert Bio: With 30+ years in audio cable manufacturing, I help global brands design connectivity solutions that survive the real world.) Table of Contents The 9-Step SOP Checklist Understanding the Hardware (Beyond ...

Short answer: xlr7 (7-pin XLR) is not one universal “plug-and-play” cable standard. In tube-mic systems, pin assignments can differ by brand and model, so the wrong cable can cause anything from noise to real hardware damage. For OEM/ODM buyers, ...

Quick Navigation Section What you’ll get Quick answer Which plug to use in 30 seconds Core differences Why “same shape” doesn’t mean “same wiring” Pin logic Presence#, Sense, and Return in pl...

Key Takeaways “3.5 mm to ft” isn’t just a conversion. Most people really mean: “How many feet can I run this cable before it sounds worse or starts buzzing?” For many passive, unbalanced 3.5mm runs, 15–20 ft is...

Key Takeaways 3.5 mm to in = 0.1378 inches (3.5 ÷ 25.4). Some people mean inches. Others mean audio IN (input/line-in). This page covers both. If a plug fits but fails, it’s often TS/TRS/TRRS confusion (and headset CTIA vs OMTP ...

Key Takeaways TRS (3-pole) stereo wiring: Tip = Left, Ring = Right, Sleeve = Ground. TRRS (4-pole) headset wiring: CTIA and OMTP look the same, but Mic and Ground swap—that’s why “audio works, mic doesn’t.” Ring count isn...

Key Takeaways xlr max length isn’t one fixed number. It depends on signal type, cable build, and the noise/grounding in your space. Balanced analog XLR usually goes farther than people think. “30 m / 100 ft” is often a convenience...

Key Takeaways Most pin jack xlr mix-ups come from wiring and grounding, not the connector shape. Balanced audio (XLR or balanced TRS) can reduce noise on long runs, but only when the gear is truly balanced. A reliable wiring table plus a short hum checkli...